Geka Offset Tooling

The offset tooling set up
 in a Geka Hyd. 55 A

Is your ironworker a Geka Hydrocrop 55, 80 or 110? If so, your machine can hold our Geka offset tooling to easily punch holes in angle. In order to use the offset punch and die holder you will need to remove the die reducer from the die block, insert the die spacer, then insert the offset die holder. For the punch portion, the punch ring (GKA3) for the F-26 punch will be used. The offset punch holder will drop into the sleeve and be screwed into the coupling nut to lock in the machine.

The two different offset die holders,
punch holder and a few punches and dies.

 Once the offset holders are in place, the punch and die can be inserted. The Geka offset tooling is a 12MM straight shank punch and a 35MM outside diameter die. The max material that can be punch is 1/8” stainless steel or ¼” mild steel. Cleveland Punch stocks the holders along with the round punches and dies. Watch the video below to see the offset tooling in action. Contact your Green Team representative today to start using offset tooling to punch angles!